(3 pcs) Atmel ATMega324A-PU Microprocessor embedded CPU 40-pin DIP pkg USA Ship

Description

Working on a project that needs lots of I/O, high speed, low power, many counters, timers, and peripherals built in?
This full-sized 40-pin DIP (prototype friendly) Atmel ATmega324A chip might be just what you need... especially at our low price.
Loaded with many features, tons of I/O ports, and a moderate amount of memory: 32k Flash, 1k EEPROM, and 2k SRAM
Don't overpay for memory you don't need!
This sale is for THREE (3) pieces with FREE SHIPPING !!!
High-performance, low-power 8-bit Atmel® AVR® Microcontroller
Complete Data Sheet
Advanced RISC architecture
131 powerful Instructions – most single-clock cycle execution
32 × 8 general purpose working registers
Fully static operation
Up to 20MIPS throughput at 20MHz
On-chip 2-cycle multiplier
High endurance non-volatile memory segments
32kBytes of In-System Self-programmable Flash program memory
1KBytes of EEPROM
2KBytes of Internal SRAM
Write/Erase Cycles: 10,000 Flash/ 100,000 EEPROM
Data retention: 20 years at 85°C/ 100 years at 25°C
Optional Boot Code Section with Independent Lock Bits
In-System Programming by On-chip Boot Program
True Read-While-Write Operation
Programming Lock for Software Security
Atmel QTouch® library support
Capacitive touch buttons, sliders and wheels
QTouch and QMatrix acquisition
Up to 64 sense channels
JTAG (IEEE std. 1149.1 Compliant) Interface
Boundary-scan Capabilities According to the JTAG Standard
Extensive On-chip Debug Support
Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG
Peripheral Features
Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode
Real Time Counter with Separate Oscillator
Six PWM Channels
8-channel, 10-bit ADC - Differential mode with selectable gain at 1×, 10× or 200×
Byte-oriented Two-wire Serial Interface
Two Programmable Serial USART
Master/Slave SPI Serial Interface
In-System Programmable Flash
Programmable Watchdog Timer with Separate On-chip Oscillator
On-chip Analog Comparator
Interrupt and Wake-up on Pin Change
Special Microcontroller Features
Power-on Reset and Programmable Brown-out Detection
Internal Calibrated RC Oscillator
External and Internal Interrupt Sources
Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby and Extended Standby
I/O and Package
32 Programmable I/O Lines
40-pin PDIP
Operating Voltages
1.8 - 5.5V
Speed
0 - 20MHz @ 1.8 - 5.5V
Power Consumption at 1MHz, 1.8V, 25°C
Active: 0.4mA
Power-down Mode: 0.1µA
Power-save Mode: 0.6µA (Including 32kHz RTC)