DJI FPV Drone 360 Camera Mount for GoPro MAX or Insta360 - NEW VERSION

Description

Mount a GoPro MAX or Insta360 on your DJI FPV drone
These mounts are mounted to rear heat sink to avoid GPS
interference and high camera stack instability
Total Weight with GoPro MAX Camera 177g
With Insta360 69g
DRONE , FPV units AND CAMERAS NOT INCLUDED
In Flight Video  05/08/21
Using GoPro MAX 360
https://youtu.be/EeY_qo17YcU
COPYRIGHT © 2021 alienconcepts incorporated
Multiple units are available
MADE IN THE USA
General for All Mounts
We are constantly updating based on field use reports . As a result photos and instructions and components may change
at any time.
Disclaimer
We offer no guarantees  that a mount will perform up to your expectations since there are too many variables.
Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.
We assume no responsibility for any damage or injury because of the addition of one of our mounts.
Payload Location and Clearance
When mounting payloads verify against recommended weights and sizes for your drone in manual or
contact manufacturer
If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next:
1-Place you DJI Inspire 1 or 2 in travel model with props on and look down from directly above make sure
you have clearance with nothing protruding outside of the drone main body envelope into prop space
2-If you do have payloads in the body envelope or you are unsure make Styrofoam size model and affix it with double stick
or velcro. Manually move the jack screw through its full range and make sure there is no interference with the props.
Safeguards
Use a safety lanyard on your mounts. This is one I use : Amazon
MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10